As an important standby power supply, diesel generator set is very important. If it is the standby generator of the unit, how to store and keep the generator set?

一、短期內不使用時的存放與保管方法：

1、 Storage and safekeeping methods when not in use in a short term:

1、放凈燃油

1. Drain the fuel

2、將發動機的活塞轉至壓縮的上止點上

2. Turn the piston of the engine to the top dead center of compression

3、移入室內存放，并用罩布蓋好，不能放置于潮濕的地方，不要與易燃、易爆及腐蝕性物品放在一起，并且要定期轉動曲軸

3. Move it into the room for storage and cover it with a cover cloth. It cannot be placed in a wet place. It should not be placed with inflammable, explosive and corrosive articles, and the crankshaft should be rotated regularly

二、長期內不使用時的存放與保管方法：

2、 Storage and safekeeping methods when not in use for a long time:

1、按短期內不使用的方法進行操作

1. Operate according to the method not used in the short term

2、清理干凈機組表面層的贓物，用壓縮空氣將機組內部吹干凈，發電機里面放滿干燥劑，用厚紙將發電機端蓋上，并且將所有通風口蓋好，并用繩子固定好。

2. Clean the dirt on the surface layer of the unit, blow the inside of the unit with compressed air, fill the generator with desiccant, cover the generator end with thick paper, cover all ventilation openings and fix them with ropes.

3、將機濾、空濾等部件中的機油放凈

3. Drain the oil in the machine filter, air filter and other components

4、從排氣歧管向每個氣缸注入100~200g機油，將曲軸轉動數十次，以便機油在氣缸內均勻分布，并使活塞處于壓縮上止點上

4. Inject 100 ~ 200g of engine oil into each cylinder from the exhaust manifold and rotate the crankshaft dozens of times so that the engine oil is evenly distributed in the cylinder and the piston is at the top dead center of compression

5、取下氣門室蓋，用脫水機油潤滑氣門的結構

5. Remove the valve cover and lubricate the valve structure with dehydrated engine oil

6、將排氣口、空濾、燃油箱通氣孔、低溫啟動裝置的排煙口等用油紙進行包封；

6. Seal the exhaust port, air filter, fuel tank vent and smoke exhaust port of low-temperature starting device with oil paper;

7、將柴油機、發電機、聯軸口、底架及發電機所有部件、工具、附件等金屬表面先用洗潔劑擦洗干凈，必要的地方可以涂上黃油

7. Clean the metal surfaces of diesel engine, generator, coupling port, underframe and all parts, tools and accessories of generator with detergent, and apply butter where necessary

8、每月?lián)u轉曲軸1~2次，每次搖轉后均應使活塞處于壓縮上止點上。

8. Crank the crankshaft 1 ~ 2 times a month, and make the piston at the compression top dead center after each crank.

以上就是為大家介紹的有關焦化氣發電機組的詳細介紹,希望對您有所幫助.如果您有什么疑問的話,歡迎聯系我們.我們將以專業的態度,為您提供服務http://

The above is the detailed introduction of coking gas generator set. I hope it will be helpful to you If you have any questions, please contact us We will provide you with professional service http://