Self switching operation steps of diesel generator set

柴油發電機組資訊報道：自切換柜(又稱ATS柜，雙電源自動切換柜、雙電源自動轉換柜)主要用于主電源和應急電源之間的自動切換，它與自啟動柴油發電機組一起組成了自動應急供電系統，可以在主電源停電后自動的將應急照明、保安電源、消防設備等負載切換到發電機組上，是醫院、銀行、電信、機場、電臺、賓館及工廠企業應急供電電源及消防電源等不可或缺的電力設施。ATS自動化電柜操作方法有2種

Diesel generator set information report: self switching cabinet (also known as ATS cabinet, dual power automatic switching cabinet and dual power automatic switching cabinet) is mainly used for automatic switching between main power supply and emergency power supply. It forms an automatic emergency power supply system together with self starting diesel generator set, which can automatically switch the loads such as emergency lighting, security power supply and fire-fighting equipment to the generator set after the main power supply is cut off. It is mainly used in hospitals, banks, telecommunications Airports, radio stations, hotels and factories are indispensable power facilities such as emergency power supply and fire power supply. There are two operation methods of ATS automatic electric cabinet

1、模塊手動操作方式：

1. Module manual operation mode:

打開電源鑰匙后，按模塊“手動”鍵直接啟動，當機組啟動成功正常運行后，與此同時自動化模塊也進入自檢狀態，它會自動進入升速狀態，升速成功后機組將會根據模塊的顯示進入自動合閘與網電并網。

After turning on the power key, press the "manual" key of the module to start directly. When the unit starts successfully and operates normally, at the same time, the automation module also enters the self inspection state, which will automatically enter the speed-up state. After the speed-up is successful, the unit will enter the automatic closing and grid connection according to the display of the module.

2、全自動操作方式：

2. Fully automatic operation mode:

將模塊設置在“自動”位置，機組進入準啟動狀態，在自動狀態下，通過外開關信號，對市電狀態自動長期檢測、判別。一旦市電有故障、失電時，即刻進入自動啟動狀態。當市電來電時，它將會自動切換分閘降速停機。當市電恢復正常后，經系統3S確認，機組自動跳閘退網，延時3分鐘，自動停機，并自動進入下一個自動啟動的準備狀態。

Set the module in the "automatic" position, and the unit enters the quasi start state. In the automatic state, the mains power state can be automatically detected and judged for a long time through the external switch signal. Once the mains power fails or loses power, it will enter the automatic start state immediately. When the mains power calls, it will automatically switch off, slow down and shut down. When the mains supply returns to normal, the unit will automatically trip and withdraw from the network after 3S confirmation of the system. After a delay of 3 minutes, it will automatically stop and automatically enter the preparation state for the next automatic start.

打開電源鑰匙直接按“自動”鍵，機組同時就會自動啟動升速，當赫茲表、頻率表，水溫表顯示正常后，他將會自動合閘送電與網電并網。準狀態自動控制、市電狀態自動檢測、機組自動啟動、自動投網、自動退網、自動停機、故障自動跳閘、停機、報警。

First, turn on the power key and directly press the "automatic" key. At the same time, the unit will automatically start to speed up. When the Hertz meter, frequency meter and water temperature meter display normally, it will automatically switch on and send power to the grid. Quasi state automatic control, automatic detection of mains power state, automatic start-up of the unit, automatic network input, automatic network withdrawal, automatic shutdown, automatic fault trip, shutdown and alarm.

本文的精彩內容由天然氣發電機組提供知識提供，本網站還有很多的精彩內容，更多的內容您可以點擊進入：http://我們有專門的客服為您解答問題

The wonderful content of this article is provided by the natural gas generator set. There are many wonderful contents on this website. You can click to enter more contents: http:// We have special customer service to answer your questions