柴油發電機組在日常使用中確實會有故障存在，而故障的類型也有很多，當對于客戶來說，并不了解故障類型，往往不清楚這些故障，為此山東祥捷動力準備給大家簡單介紹下常見的幾個故障。

Diesel generator sets do indeed have faults in daily use, and there are many types of faults. When customers are not familiar with the types of faults, they often do not understand these faults. Therefore, Shandong Xiangjie Power is ready to briefly introduce several common faults to everyone.

機械故障：

Mechanical failure:

軸承問題：軸承磨損、潤滑不良等，可能導致發電機組運行不穩定，甚至停機。

Bearing problems: Bearing wear, poor lubrication, etc. may cause unstable operation of the generator set, and even shutdown.

冷卻系統故障：水道堵塞、散熱器故障等，可能導致發電機組過熱。

Cooling system malfunction: blockage of water channels, radiator failure, etc., may cause overheating of the generator set.

振動和噪音：由于機械部件松動、不平衡或損壞，可能產生異常的震動和噪音。

Vibration and noise: Abnormal vibration and noise may occur due to loose, unbalanced, or damaged mechanical components.

電氣故障：

Electrical fault:

發電機勵磁系統故障：如主勵磁故障，可能導致發電機沒有勵磁電流或勵磁電流過大。

Generator excitation system failure: If the main excitation fails, it may cause the generator to have no excitation current or excessive excitation current.

發電機絕緣故障：絕緣老化和損壞、絕緣擊穿等，可能導致電氣性能下降，甚至引發短路。

Generator insulation failure: insulation aging and damage, insulation breakdown, etc., may lead to a decrease in electrical performance, and even cause short circuits.

電氣接觸不良：接線端子松動或腐蝕，可能導致電流傳輸不暢，引發電氣火花或加熱。

Poor electrical contact: Loose or corroded wiring terminals may cause poor current transmission, leading to electrical sparks or heating.

燃油系統故障：

Fuel system malfunction:

供油不暢：燃油泵故障、燃油濾清器堵塞等，可能導致發電機功率不足或停機。

Poor fuel supply: Fuel pump failure, fuel filter blockage, etc. may cause insufficient power or shutdown of the generator.

燃油質量問題：如燃油含水量超標、燃油質量差，可能導致發電機冒白煙、功率下降等。

Fuel quality issues: such as excessive water content and poor fuel quality, may lead to white smoke and reduced power from the generator.

控制系統故障：

Control system malfunction:

控制模塊故障：如調速器、電壓調節器等損壞或失調，可能影響發電機的輸出穩定性。

Control module malfunction: Damage or misalignment of speed controllers, voltage regulators, etc. may affect the output stability of the generator.

傳感器故障：如溫度傳感器、壓力傳感器等失效，可能導致控制系統誤判或失效。

Sensor failure: Failure of temperature sensors, pressure sensors, etc. may lead to misjudgment or failure of the control system.

其他故障：

Other faults:

發電機組漏油：由于密封件老化或損壞，可能導致潤滑油或燃油泄漏。

Generator unit oil leakage: Due to aging or damage to the sealing components, it may cause lubricating oil or fuel leakage.

啟動困難：電池電壓過低、啟動回路故障等，可能導致發電機組無法啟動。

Difficulty starting: Low battery voltage, starting circuit failure, etc. may cause the generator set to fail to start.

本文由 生物質氣發電機組友情奉獻.更多有關的知識請點擊: http://真誠的態度.為您提供為全面的服務.更多有關的知識我們將會陸續向大家奉獻.敬請期待.

This article is a friendly contribution from biomass gas power generation units. For more related knowledge, please click: http://t Sincere attitude. We will provide you with comprehensive service. We will gradually contribute more relevant knowledge to everyone. Stay tuned